HONDA ELITE SA50P

Instructions for ordering: check jet dimensions. If the jet in the carb does not dimensionally measure like ours, then it is not correct. Do not buy it! It will not work. Try here: identify that jet.

Our year, make, and model fitment guides list jets for popular factory and aftermarket carbs, but due to numerous reasons there is not a way to make them 100% accurate. Therefore, do not rely on the fitment guides.  See also additional things to check before ordering.If you need help send us a picture of the jets removed from the carb. identify that jet can help as well. 
Please take a moment right now to measure the jet prior to ordering. Taking a bit of time now will help avoid issues later.

We have no control over jets once they leave us. Some people drill them out, test and tune, etc. To protect everyone from getting used and abused jets, jet sales are final. No exchanges or returns.

Help us help you! Please measure the jets before ordering and email with any questions. It is easier to check now then potentially have jets arrive that do not match!

*** All jet sales are final. No returns or exchanges.**** 

TYPICAL JET SIZE:
Main Jet - *
Slow Jet - *
*Typical size only- verify jet size and compare dimensions to those listed before ordering. See Jet Finder for other jets available.

SLOW/PILOT JETS price each jet
 
MAIN JETS price each jet
 
carb bowl screws
CARB BOWL SCREW - Sold each, modify cart for desired quantity *
Stainless steel allen head screw for carb bowl.
Length dimension is the shaft length of the fastener not including the length of the head.
Example: M4 x 10 (10 mm shaft length)
Sold each carb bowl screw M4 x 10 (0.39") $1.49
Sold each carb bowl screw M4 x 12 (0.47") $1.55
Sold each carb bowl screw M4 x 14 (0.55") $1.59
Sold each carb bowl screw M5 x 16 (0.62") $1.61
Sold each carb bowl screw M5 x 20 (0.78") $1.63

NEEDLE SHIM WASHERS
Stainless washers.
Used to raise the needle, stack multiple washers to raise needle higher in various increments.

Needle shim most Mikuni 2.7mm ID x 6.30mm OD 0125A2M2.7 JRU-8027A 10 pieces

Needle shim most Keihin 3.2mm ID x 7mm OD 0125A2M3.2 JRU-8032 10 pieces

Needle shim 3.7mm ID x 7.9mm OD 0125A2M3.7 JRU-8037B 10 pieces

wrench_hex_carb_bowl
HEX wrench for carb bowl screws
hex wrench
Metric hex wrench short arm for screws $0.87
Extra short arm ball end for tight fitting areas 19109

TORX wrench for carb bowl screws
Extra short arm for tight fitting areas TORX 19110- note our screws are hex, this item is placed here as some carbs use torx screws.